1
2
4
Buttons
ON/STANDBY Button:
Switch the Operating Mode:
While the UPS is plugged into a live
AC outlet, press the
ON/STANDBY
button and hold it until the UPS
beeps (about 2 seconds) to toggle between
ON
and
STANDBY.
• ON Mode:
ENABLES battery backup.
UPS Conditions:
The UPS
charges the battery and supplies power to the outlets while
receiving utility line power. The “
” indicator light will illuminate.
If utility power fails, the UPS provides power from battery.
Cold-Start:
Cold start the UPS to use it as a stand-alone power
source when utility power is not present (if the UPS battery is
charged). To cold start the UPS, press and hold the
ON/STANDBY
button until the UPS beeps (about 2 seconds), then release it.
The “
” indicator will illuminate and AC power inverted from stored
battery power will be provided to the outlets.
These connections are optional. The UPS will function properly without these
connections.
Quick Installation
(optional)
1
Phone Line/Network
Line Surge Suppression
The UPS has jacks which protect
against surges over a phone or
network data line.
Using telephone cords or network
data cables as appropriate, connect
the wall jack to the UPS jack marked
“IN.” Connect equipment to the UPS
jack marked “OUT.” Make sure the
equipment connected to the UPS
jacks is also protected against
surges on the AC line.
2
USB Communications
Use any USB cable to connect the
computer’s USB port to the USB port
of the UPS. Download the PowerAlert
UPS monitoring software program
appropriate for the computer’s
operating system from www.tripplite.
com/software/ and install it.
Basic Operation
201109015-93-3103.indb 4
9/9/2011 9:50:05 AM
