Power Supply Module &
Battery Module Mounting
Attach the Power Supply Module to the
mounting bracket using the included
hardware.* Make sure the Power Supply
Module is oriented as shown in the diagram,
with its outlets facing up.
Attach included hardware to the bottom of
the mounting bracket.** Fully tighten the
screws. (NOTE: These screws are designed to
protrude downward even when fully tightened
in order to engage the cart’s legs in step 1B.)
Using one or more assistants, lift the Power
Supply Module/mounting bracket and place it
around the cart's center pole as shown.
(NOTE: Since the mounting bracket is
designed to accommodate a wide variety of
center pole sizes, attach the screw clamps as
described in step 1C.) When lowering the
mounting bracket into place, make sure that
the screws on the bottom of the bracket
engage the cart's legs in order to prevent the
retrofit kit from rotating around the cart's
center pole. To minimize rotation, make sure
the side of the mounting bracket is
perpendicular (90°) in relation to one of the
cart's legs, as shown in the “Top View”
diagram. Lift and readjust if needed.
The mounting bracket is designed to
accommodate a wide variety of center pole
sizes. To secure bracket to center pole, wrap
the two included screw clamps around the
cart's center pole and through the raised slots
on the mounting bracket. Use a screwdriver to
fully tighten clamps.
Using one or more assistants, lift the Battery
Supply Module and attach it to the Power
Supply Module/mounting bracket as shown
using the mounting flanges and included
hardware.***
* Four phillips-head screws (3/8 in. long, 10-32 size) and
four star washers (#10).
** Two phillips-head screws (1 in. long, 10-32 size).
Two fender washers (#10).
*** Four hex bolts (1-5/8 in. long, 5/16-18 size),
four hex nuts (5/16-18), four star washers (5/16)
and four flat washers.
1
LEG
MOUNTING BRACKET
CENTER
POLE
90°
Top View
1A
1B
1C
Remote User Interface
(RUI) Mounting
Mount the RUI to the top edge of the
mounting bracket with included screws.
Or, if desired, use the included double-sided
tape to secure the RUI to any flat surface on
the cart.
2
1A
1B
1C
2
4
Mounting
continued
1D
1D
200612036 93-2613 Retrofit Kit 1 OM.qxd 12/7/2006 11:06 AM Page 4