7
2
Digital Display:
Shows source status, measured values, display modes and other information.
See the
Digital Display
section for detailed explanations of the indicators and displays.
3
Network Interface:
Use the RJ-45 jack to connect the ATS to the network
with a shielded Ethernet patch cable. The Status LED
A
and Link LED
B
indicate operating conditions as shown in the table below. These ports are
not compatible with PoE (Power Over Ethernet) applications.
Network Operating Conditions
A
Status LED Color
B
Link LED Color
Off
Card Not Initialized
Off
No Network Connection
Steady Green
Card Initialized and Operational
Flashing Amber
100 Mbps Network Connection
Flashing Amber
Error - Card Not Initialized
Flashing Green
10 Mbps Network Connection
4
Mini-DIN Serial Port:
Use this port to provide a direct terminal connection to a computer
with a terminal emulation program.
5
PS/2 Port:
Use this port to connect a Tripp Lite ENVIROSENSE environmental sensor to
provide remote temperature/humidity monitoring and a dry contact interface to control and
monitor alarm, security and telecom devices.
6
SNMP Reset Button:
Press the reset button for 3 seconds to reboot the ATS network card.
Rebooting the network card will not erase network settings or interrupt AC power. The reset
button is recessed. Use a paper clip or other suitable object to press it.
7
ATS Output:
This cord is permanently attached to the ATS (see chart on pg. 4).
8
Chassis Ground Screw:
Use this to connect equipment that requires a chassis ground.
3. Features
A
B
15-09-215-93338F.indb 7
9/30/2015 4:56:29 PM
