TriPollar pose, Руководство пользователя, Страница: 9 / 12

7
Built-In Safety Mechanism & Indicators:
The TriPollar
®
POSE
™
device has an automatic temperature monitoring
mechanism. When the skin temperature reaches a pre-programmed
temperature, the TriPollar
®
RF energy will alternately turn off and on
automatically to prevent overheating of your skin. At that moment, the
green light indicator will blink.
3. Choose your treatment area; arms, abdomen, thighs, hips, buttocks
or waist. Visually divide the selected treatment area into small work
areas. Each working area should be approximately about the size of
your palm.
4. Place the TriPollar
®
POSE
™
device against your skin making sure
all electronic tips are in full contact with the skin at all times.
Start moving the device in slow circular motions, slowly heating
your skin to the optimal temperature. Once the orange indicator
light illuminates continue the same circular motions for a few
moments before progressing to the next adjacent palm size area.
Repeat this technique one palm size area at a time until the entire
treatment area has been covered.
Note: If after repeating this process at a slow pace possible the orange
indicator light still does not appear, discontinue use and contact local
service center.
5. Now, go over the entire treatment area in larger sweeping circles
to rewarm the entire area without waiting for the orange indicator
light to illuminate. You have completed your treatment once you
have warmed the entire treatment area for a second time.
Warning!
Do not stop movement at anytime while device is touching your skin, as this
may cause skin to overheat and cause possible unwanted side effects.
After treatment
1. When your treatment session is completed, turn the TriPollar
®
POSE
™
device off by pressing the power button for 2-3 seconds.
Note: Device will automatically shut down after 20 minutes if
not used.
2. Clean the treated areas of your body thoroughly with warm water
and mild soap to remove any residual TriPollar
®
Preparation Gel.
• The orange indicator light notifies you when your skin has
reached the optimal temperature. If the orange
indicator light take longer than 5 minutes to illuminate in any
single treatment area, try slowing down the circular motions.
• If the orange indicator light goes on immediately select a
higher power level.
• It is not necessary to use any downward pressure when
holding the device against your skin.
• Slow, circular and constant movements are more effective
than rapid movements. The slower the movement, the faster
the treatment area will begin to heat internally.
• If you do not feel any heating of the skin even on highest
power level, try moving as slowly as possible without stopping
the motion of the device.
• Skin properties and sensations vary considerably from one
area of the body to another and from one person to another.
You must use the device according to your own comfort level.
tips