3.
When downloading the data to the PC, “
-PC-
” will be displayed
on the
LCD. After the download is complete, the datalogger will display
the last value recorded, but it will stop recording. The logger needs
to be re-set from the software to begin a new recording session.
4.
The “REC” LED will flash at the programmed rate
when the unit is
datalogging.
5. Alarm function: When the measured value exceeds the
programmed upper or lower limit and the LED function is
selected in the software, the ALM LED will flash one time per
minute.
6.
If “
-LO-
“ is
displayed, the temperature and humidity sensors need
attention.
7. The datalogger should be placed upright when in use.
8. If used in low temperature, high humidity environment, the datalogger
should be placed upright in a dry area to remove any condensation
before downloading the data.
9. Battery life can be extended by leaving the datalogger connected to a
pc.
10.
Disabling the REC and ALM LED’s will extend battery life.
11. The LCD display will stop functioning at very low temperatures
and will become active again when the unit is returned to higher
temperatures.
NOTE: The logger needs to be re-set from the software to begin a new
recording session.
Combination Lock
The logger is supplied with a wall mount case and
security combination lock. The lock is shipped with a -0-
0-0- code as viewed from the side with the alignment
bar. To change the code:
1.
Press the release to open the lock (1)
2.
Using a pointed object, press IN and HOLD the
locking pin on the bottom of the lock (2).
3.
Set the new code (3) and release the locking pin
