Unit
Measurement
1. Single measurement
In the length measurement mode, press
【
】
key to open the laser.
After the laser aims at the object, press
【
】
key to carry out measure-
ment. The measurement result is displayed at main display area. The
auxiliary display area displays the distanced measured last time.
2. Continuous measurement
The continuous measurement function may enable users to start from one
measurement point and find a distance point or measure the minimum or
maximum distance. For example, measure the diagonal distance (maximum
value) or vertical distance (minimum value) of a room.
In the length measurement mode, hold down
【
】
key to enter the
continuous measurement mode and the buzzer sounds. The auxiliary display
area on the screen displays the measured maximum value (MAX) and
minimum value (MIN). The main display area displays the currently measured
distance. Press [ ] key to exit from the continuous measurement mode.
3. Area measurement
Press
【
】
key once and the screen displays . The edge to be
measured flashes to prompt. Press
【
】
key to complete measure-
ment of length and width respectively and the instrument calculates the area
automatically.
4. Volume measurement
Press
【
】
key twice and the screen displays . The edge to be
measured flashes to prompt. Press
【
】
key to complete measurement
of length and width and height respectively and the instrument calculates the
volume automatically.
7. Check historical record
The instrument saves 20 groups of latest data automatically. The new data
overwrites the old data in proper order. In the length measurement mode,
press
【
】
key to enter historical record mode. Press
【
】
and
【
】
key to check the data. Press
【
】
to exit.
8. Unit setting
Press[ ] key to switch the unit.
6
7
The operating method is as follows:
In the interface, press
【
】
key to set the laser (the
laser symbol on top left of the screen displays or
disappears).
The laser symbol appears: indicate that the laser will open
automatically after powering on.
The laser symbol disappears: indicate that the laser will not
open automatically after powering on.
Hold down
【
】
key for about 2 seconds and it enters data calibration
interface. press
【
】
key to adjust the parameters from -7mm to+7mm.
Hold down
【
】
key for 2 seconds to exit from the setting
state.
Hold down
【
】
key for about
2 seconds and it enters buzzer
setting interface. press
【
】
key to select on or off.
www.triplett.com
UM-LD70
