Triple S PV-12, Инструкция по эксплуатации и обслуживанию

Страница: 4 / 10

4
MAINTENANCE
Good maintenance procedures assure better operation, fewer
repairs and longer life to your machine.
DISCONNECT THE ELECTRICAL PLUG OF THE
MACHINE FROM THE ELECTRICAL OUTLET
BEFORE DOING ANY CLEANUP, REPAIRS OR
MAINTENANCE OF THE MACHINE AND WHEN
LEAVING THE MACHINE UNATTENDED.
CLEAN THE MACHINE AFTER EACH USE:
1.
Wipe the outside with a clean cloth
.
2.
Clean the collector tank
: Release the clamps on each
side of the tank and head assembly. Lift the head as-
sembly off and set aside. Lift the filter assembly out of
the collector tank and set aside. Then wipe the inside
of the collector tank with a clean cloth.
3.
Empty and check the filter assembly
: Empty the re-
covered soilage into a suitable container and shake to
remove clinging dirt. Brush the outside of the filter bag
to remove embedded dirt. Check the filter assembly for
tears or holes; repair or replace if necessary. Install the
clean filter assembly into the clean collector tank.
ELECTRICAL CABLE:
Check the cord for any nicks, cuts or damage. Report
these to your supervisor for correction.
VACUUM HEAD ASSEMBLY:
1. Gaskets : Clean the vacuum head gasket (23) and the
float shut-off gasket (24).
2. Float Shut-Off Device : This should move freely. Re-
move any debris or strings from the float cage.
3. Head Assembly : Replace and leave ajar if the collector
tank is damp to prevent mildew.
WHEELS AND CASTERS:
Check these for cuts and nicks. Remove any strings or
debris that may restrict the free movement of the wheels.
Wipe the treads clean.
CARBON BRUSH INSPECTION:
Check for wear at six month intervals or every 600 hours
of operation. The carbon brushes must be replaced if worn
shorter than 3/8 inch.