Triple S Ace 26T1, Руководство пользователя

Страница: 9 / 35

Page 9 of 35
MACHINE OPERATION
10) MACHINE MOTION
This machine is equipped with traction wheel
propulsion. To move machine forward, rock
traction directional switch forward and depress
the handle switch lever. Adjust the forward
speed with the traction drive speed control knob.
During the first few yards of operation, check that
the quantity of the cleaning solution is sufficient
to wet the floor and that the squeegee dries the
floor surface. To move machine in reverse, lift
the squeegee assembly with the squeegee lift
lever and rock traction directional switch
rearward and depress the handle switch lever.
WARNING! Always lift the squeegee
when moving backwards.
11) SCRUBBING
Depress the handle switch lever. The scrub
brush will begin to rotate and solution will begin
to flow. During the first few yards of operation,
check that the quantity of the cleaning solution is
sufficient to wet the floor and that the squeegee
dries the floor surface.
WARNING! Always lift the squeegee
when moving backwards.
12) OVER FILL PROTECTION
The machine is equipped with a float that stops
the vacuum exhaust air flow when the recovery
tank is full. Vacuum motor does not stop
operating but the vacuum exhaust air flow rate is
greatly reduced. When this occurs, empty the
recovery tank by removing the drain plug on the
drain hose and then empty the recovery tank.
WARNING! Use gloves for protection from
contact with dangerous solutions.
Handle
Switch
Lever
Traction
Directional
Switch
Traction Drive
Speed Control
Drain Plug
Float