Trinnov Audio Amplitude 16, Руководство пользователя

Страница: 4 / 9

7 6
AMPLITUDE
16
USER MANUAL
SPECIFICATIONS
ABOUT THE AMPLITUDE
16
SPECIFICATIONS
PRESENTATION
Like all Trinnov power amplifiers, the Amplitude
16
is designed to match the Altitude AV Processor range.
This match is achieved both in aesthetics and performance. The input level sensitivity of the Amplitude
16
matches perfectly the Altitude output level to maximize dynamic range and signal-to-noise ratio. To
extract maximum performance, a custom dual power supply and a bespoke thermal dissipation design
have been developed.
Feature rich, the Amplitude
16
also provides unprecedented versatility. With the ability to bridge any pair of
channels, the Amplitude
16
meets the various requirements of immersive sound home theaters.
IMPORTANT RECOMMENDATION
Before turning on your Amplitude
16
, make sure you are using the right fuses: 2x 10A 5x20mm slow blow.
Use both Power Inlets.
AUDIO POWER
ONE CHANNEL 8Ω 200W - 1kHz, 0,1%< THD+N
ONE CHANNEL 4Ω 400W - 1kHz, 0,1%< THD+N
ONE CHANNEL BRIDGED 8Ω 800W - 1kHz, 0,1%< THD+N
ONE CHANNEL BRIDGED 4Ω 1000W - 1kHz, 0,1%< THD+N
TOTAL OUTPUT POWER
(SE or BTL)
2800W all channels driven @40°C continuous, 120 VAC
3200W all channels driven @40°C continuous, 230 VAC
GAIN 16 dB single ended / 22 dB bridged
AUDIO PERFORMANCE
THD+N SINGLE ENDED 0.0015% - 8Ω, 5W (2dBu)
THD+N BRIDGED 0.0015% - 8Ω, 20W (8dBu)
FREQUENCY RESPONSE +0/-0,6 dB 20 Hz to 20 kHz, load-independent
DAMPING FACTOR 2340 at 100Hz / 1820 at 1kHz / 354 at 10kHz
SIGNAL TO NOISE RATIO 126 dB referenced to rated 1% THD output (A-Weighted)
CROSSTALK 96 dB single ended 200W 8Ω
POWER SUPPLY
POWER REQUIREMENTS 2x 100/240V (auto-selecting)
POWER CONSUMPTION 0,5W< at Standby; 125W at idle; Max 2x 2000W fully loaded
THERMAL CONVERSION 683 BTU/h MAX
MAINS FUSE 2x 10 Amp slow blow for different Voltages & Countries
TRIGGER INPUT 5-15 VDC; Steady State (mini-jack TS)
TRIGGER OUTPUT 8-10 VDC; Steady State (mini-jack TS)
MODES /PROCESS
Standby: Amplifier is ready to be turned on via front panel switch or
remote trigger.
Overcurrent, D.C., and/or thermal protection: Amplifier will cycle.
Catastrophic D.C. or output stage failure: Amplifier will shut down.
AUDIO INPUTS & OUTPUTS
INPUT CONNECTOR 2x DB25 Female, Tascam Analog Pinout
INPUT IMPEDANCE 47kΩ, each phase
INPUT SENSITIVITY 6.16V (+18dBu) RMS balanced in = 200W into 8Ω single ended out
OUTPUT CONNECTOR 1x 5 way binding post per channel