ASSEMBLY INSTRUCTIONS
Locate DRAWER FRAME (B) from the box and notice
that both DRAWERS (I) are preinstalled.
You will need to remove both DRAWERS (I) before
starting assembly of the Kitchen Cart.
Push one DRAWER (I) out from inside the DRAWER
FRAME (B) so that it is almost fully extended. Keep the
other DRAWER (I) closed so you can reach release levers
on both sides. On the LEFT-hand side, pull the black
release lever UP. On the RIGHT-hand side, push the
black release lever DOWN. While holding the levers as
instructed, pull the DRAWER (I) forward until released
from the slides attached to the DRAWER FRAME (B).
Repeat for the other DRAWER (I) so that both
DRAWERS (I) are removed. Set both aside.
© 2017 TRINITY - 800.985.5506
2
STEP 1
B (1)
I (2)
On a clean surface, lay the WOOD TOP (A) on its
top surface, the side without the holes.
Insert (4) DOWELS (N) into the (4) inside holes of
each corner of the WOOD TOP (A).
Carefully place DRAWER FRAME (B) over the
DOWELS (N), aligning the (4) holes closest to
each corner of the DRAWER FRAME (B) with the
(4) DOWELS (N). Then push down evenly until
DRAWER FRAME (B) is pressed against WOOD
TOP (A).
Insert FRAME SCREW (L) through DRAWER
FRAME (B) and fasten to WOOD TOP (A) using
SCREWDRIVER (O). Make sure all SCREWS (L) are
tightened.
Left-hand side
Right-hand side
STEP 2
A (1)
B (1)
B
I
O (1)
N (4)
L (4)
A
N
B
L
O