ASSEMBLY INSTRUCTIONS
STEP 1
Location of parts:
1) KEYS (F) are hooked to the key leash that is
mounted in the TOP MIDDLE Drawer.
2) 2) CASTERS (B/C) and CASTER BOLTS (D) are
boxed and put in the BOTTOM LEFT Drawer.
3) LINERS (E) are in the BOTTOM RIGHT Drawer
1
2
© 2021 TRINITY - 800.985.5506
2
STEP 2
B (2)
C (2)
D (16)
Lay WORKBENCH (A) on its backside. Lift
workbench by side handles. Do NOT lift
workbench by the wood top. Two people are
needed. Do NOT attempt this alone.
Position LOCKING CASTERS (B) on side of
WORKBENCH (A) of your choice and align holes to
pre-installed nuts on underside of WORKBENCH
(A). Use a 14mm socket wrench to fully tighten
CASTER BOLT (D) to WORKBENCH (A).
Repeat above steps to install NON-LOCKING
CASTERS (C).
Notes:
* Make sure to install both LOCKING CASTERS (B)
on same side of workbench.
** For ease of use, place LOCKING CASTERS (B) on
side you will regularly push or pull.
*** If you plan to push the workbench against a
wall, place LOCKING CASTERS (B) on front long side
for ease of access.
14mm
A
C
B
D
3