Triner Scale TS60-1010, Инструкция по сборке, Страница: 8 / 20

Assembly Guide TS60-1010 Platform Scale
6
11) Attach the Ramps to the Weighing Base
SYNOPSIS:
The ramps are placed into position at the end of the weighing deck, then the weighing
deck is lowered to the floor, one corner at a time. The two load cell feet at the end of the
weighing deck fit into holes in the ramp tabs, as shown in Fig. 9.
a) ALIGN THE FIRST RAMP: Using a forklift, position the ramp near the weighing
deck so that the large tabs are aligned with the feet located at the end of the weighing
deck, as shown in Fig. 10.
b) LOWER ONE CORNER OF THE WEIGHING DECK INTO THE LOAD CELL
FOOT HOLE: Using a 5 lb rubber mallet, strike the handle of the ramp to move the ramp
into position directly under the load cell foot (alternatively, a long pry bar may be used to
move the ramp into final position). Using a forklift, lift the end of the weighing deck
enough to remove the end block(s), then slowly lower the deck into position, making sure
the load cell foot fits into the foot hole in the ramp tab.
NOTE: If required, rearrange the blocks in a way so as each corner of the weighing deck
can be individually lowered into the ramp tab foot holes.
c) LOWER THE OTHER CORNER OF THE WEIGHING DECK INTO THE
REMAINING LOAD CELL FOOT HOLE OF THE SAME RAMP: Follow the
instructions in Step b above to complete the attachment of the ramp to the weighing deck.
d) FOLLOW STEPS A THROUGH C ABOVE TO ATTACH THE SECOND RAMP
TO THE WEIGHING DECK. After both ramps are attached, the weighing deck will be
fully lowered to the floor.
12) Adjust the Load Cell Feet to Assure the Weighing Deck is Level and Stable
a) ADJUST THE FOUR CORNER FEET: Using a 27 mm wrench, adjust the corner feet
as needed to obtain a level weighing deck. Be sure the weighing deck does not rock or tilt
from corner to corner.
b) ADJUST THE TWO MIDDLE FEET: Using a 27 mm wrench, adjust the two middle
feet downward until a solid contact is made with the floor.
13) Connect the Digital Indicator and Check Scale Operation
a) MOUNT THE INDICATOR BRACKET TO THE INDICATOR STAND: Using the
provided bolts, bolt the indicator bracket to the indicator stand. Place the stand in the
desired location of use.
b) CONNECT THE DIGITAL INDICATOR TO THE WEIGHING DECK: Connect the
digital indicator cable lead from the junction box to the short cable lead from the digital
indicator. Plug the digital indicator in to 110VAC. Check operation of the scale and
digital indicator.