Teaching Additional
FOB Transmitters
Programming
Button / LED
1. Turn ignition off (or confirm no connection to pin 7 of 10 pin connector-yellow wire).
2. Press and release the programming button 3 times. The LED will turn on after about 2
seconds.
3. Press and release any button of each new FOB transmitter once. The LED will flash off
once for each fob. Up to 4 transmitters may be programmed at one time.
4. After the 4th FOB, or after 10 seconds, the LED will turn off, indicating that the system
is back in normal mode.
5. Confirm that each FOB transmitter lock/unlock system.
Notes:
If you place the system in learn mode and teach nothing, the system will exit in 10 sec-
onds and nothing will change.
All previous transmitters are erased if a transmitter is taught during a programming
session, so all transmitters must be taught in the same session to retain functionality.
This device complies with Part 15 of FCC rules. Operation is subject to the following condi-
tions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this device.
TM-Multi RF Receiver
22314-01
