19. Install the front wheel motor assembly.
•
Slide the motor assembly over the steering post.
•
Press in the steering post pin and slide the motor
assembly over it until the pin snaps into place.
•
Note: The front wheel motor assembly plastic fender may
be loose. If this is the case, try the following techniques:
i.
Remove the fender and use superglue around
the base of the sleeve where the sleeve will
contact the inner tube of the motor assembly
fork. Quickly place the fender assembly in place
and allow the glue to set.
ii.
Remove the fender assembly and expand the
outer radius of the fender sleeve by heating the
sleeve with a hot air blow gun. Use Caution with
this technique as the heat gun may melt the
fender material or cause a fire. Once the sleeve
is heated, use a socket from a socket-wrench set
that is one size larger than the current inner
radius of the sleeve and push the socket through
the sleeve. This will expand the radius of the
sleeve. Install the fender back into place.
•
Tighten the 5mm Allen socket bolts.
i.
