Trikke Colt Owner’s Manual - V0 11/18/14 -
page 10
4.2
- Fit the fork to the steering axle. The fork
assembly must be first positioned 90 degrees to the
working direction in order to slide it all the way in,
then be turned to the final position where the push-
pin will snap in the hole. See image below.
4.3
- Depress the locking pin and slide the fork the
final inch, rotating up to final position - until the
locking pin snaps into the slot. "Slightly tighten" the 2
bolts at the fork clamp.
4.4
- Alignment of front fork with handlebar:
4.4.1 -
Flip the Trikke to riding position.
4.4.2
- Step on the vehicle, hold it with both
hands on the handlebars and look down
the front tube. Fine adjust the front fork
position by aligning the
tire 90 degrees to the
handlebar. You may ask
someone to hold the
front wheel while you
perform the alignment.
4.5
- Use the 5mm Hex
wrench to
firmly
tighten the
two bolts that secure the
fork to the steering axle.
STEP 5
Connecting the Motor Cable to the
Controller
5.1 -
Route the motor cable and use the supplied
plastic tie to secure it to the frame as shown on the
image.
This is very important in order to allow
enough slack on the cable while turning the wheel
left-and-right.
Allen
wrench
5mm
4.4
4.3
4.3
4.5
Cable slack
Plastic tie
(supplied)
Содержание Colt
Страница 1: ...Trikke EV Colt Owner s Manual v0 11 18 14 Owner s Manual ...
Страница 33: ...trikke com ...