EN
2
DRAFT COPY
FUNC
Pressing the FUNC button provides access to flight ID setup, flight timer,
stopwatch, ADS-B monitor (depending on installation) and altitude monitor
functions, in that order.
VFR
Pressing the VFR button sets the transponder to the pre-programmed
conspicuity code. Pressing the button again restores the previous squawk
code.
ENT
The ENT button confirms options and menu selections.
Squawk Code Entry
Press any of the numeric buttons (0 through 7) to change the squawk code. A new
squawk code is set when the fourth digit is entered. If the code entry is not completed
within 7 seconds, the changes are ignored and the previous code restored.
Some standard squawk codes are listed below
1200
VFR code in the USA
7000
VFR code commonly used in Europe
7500
Hijack code
7600
Loss of communications
7700
Emergency code
Setting Flight ID
Select the Flight ID screen using the FUNC button and press ENT to edit the Flight ID
using the number buttons corresponding to the letters A-Z and numbers 8 and 9.
Repeatedly pressing the number button will cycle through the letters shown
underneath the number on the lower portion of the display. Press ENT to select the
character and advance to the next character. The flight ID is terminated with a “space”
character located on the 7 button or when all eight characters are set. When ENT is
pressed on the last character, the new Flight ID will replace the previous value.
The Flight ID should correspond to the aircraft call sign entered on your flight plan. If
no flight plan is active, the aircraft registration should be used as your Flight ID. Use
only letters and digits.
