15
16
!
!
Please keep the washer with neat appearance and perform correct
maintenance to prolong the service life of washer.
Make sure to pull out the power plug before the cleaning and maintenance.
Cleaning of water inlet hose joint
Unscrew and remove the water inlet
hose joint from the washer and clean
the filtering screen of inlet valve with
brush.
！
！
NOTICE
Cleaning and Maintenance of the washing machine
No
washing
Abnormal
draining
Abnormal
spin
Identify usual trouble of washer
List of faults and inspection
Faults
Inspection Items
No water
flows in
!
If the power is off or the fuse is burned out.
!
If the water supply is cut off or the water pressure is too low.
!
If the inlet hose is properly connected and the water tap is opened.
!
If the filtering screen of inlet valve is blocked by dirt.
!
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is normal phenomenon when the inlet valve is switched on)
!
If the "Start / Pause" button is pressed after the power
switch is pressed.
!
If the door lid is closed.
!
If all clothing piled largely at one side of barrel or the clothing
is excessively placed.
!
If the washer is not placed in stable condition or it is placed in
inclination state. (The ground is not flat).
!
If the motor belt is loosened.
Note: During the de spin process, if washing are piled at one side of the spin barrel,
it will cause unbalance of spin barrel resulting in striking. At this moment, the
computer inside the washer will feel this unbalance phenomenon and will automatically
correct it ( fill in water Washing ). However, if unbalance situation is not removed after
continuous three corrections, which means the computer auto-correction can not
resolve the problem. Then the user has to manually and evenly place the clothing
inside the barrel to solve the problem.
When the washer is in trouble, please contact local service office or the sales service
department of our company and the customer should not dismantle the machine without
permission.
If the washer can not work normally, or appear abnormity or alarms, please check and
correct asfollows.
!
If the water drain hose is placed very high.
!
If the end of water drain hose is sealed in pond.
!
If the internal rubber ring of drain valve is blocked by dirt.
!
If the power is off or the fuse is burned out.
!
If the power supply voltage is too low.
!
If the water amount reaches to the required water level.
(The washer will not work if the water amount does not reach the
required water level)
!
If it is set to "Delay" washing mode. (It will only start to work
until the reservation time reached)
