Tridonic luxCONTROL DaLI Msensor 5DPI 14, Руководство по эксплуатации продукта

Страница: 35 / 52

Product manual DALI MSensor 5DPI 14 | 06-2017 | 1.1 | en
Special DALI settings
c
31 / 48
7. Special DALI settings
7.1. DALI concept
The behaviour of control devices is not currently described in the DALI standard. This is why the DALI MSensor
responds to some DALI commands in a special manner, as defined by Tridonic. This ensures that the DALI
MSensor can be optimally combined with other products in the comfortDIM product range.
The DALI MSensor is designed so that it can be combined with other DALI controllers. This is why the sensor
responds to some DALI commands in a different way than that specified in the official DALI standard. This ensures
that other DALI controllers, e.g. the DALI SC or x/e-touchPanel, can be used to affect light control.
Like DALI control gear, the DALI MSensor reacts to commands that are sent to it, i.e. commands sent to its DALI
address, DALI group (luminaire group), or to broadcast commands.
7.2. Reaction to DALI commands
The DALI MSensor sometimes distinguishes whether commands are sent to its DALI address or to its DALI group or
whether commands are broadcast commands. This chapter deals with the most important commands for
communicating with other controllers and confines itself to broadcast or group commands. A detailed overview of
supported DALI commands sent to a DALI address can be found in the annex.
7.2.1. Direct setpoint invocation (DALI "Direct Arc Power x" command)
In the case of direct setpoint invocation, a distinction must be made between setpoint commands greater than 0%
and setpoint commands equal to 0%. Setpoint commands greater than 0% act as a switch-on command. The
following behaviour applies for these:
Please pay attention to notes concerning DALI commands ! _
When used in combination with other manufacturers' controllers: please check compatibility! _