Technical Design-in Guide Engine LLE G2 PRE KIT | 03-2020 | 1.2 | en
Summary of the chapters
c
5 / 63
To make it easier to find your way around the Design-in Guide we have grouped the information on the LLE G2 PRE KIT systems into
chapters.
The guide begins with a system overview in which the different versions of the system are presented. The mechanical, electronic,
optical and thermal aspects of the components are then described. At the end of the Design-in Guide you will find ordering
information and sources.
2.1. System overview
The LLE G2 PRE KIT system is available with different properties and functions. The relevant components can be clearly assigned by
their type codes.
2.2. Mechanical aspects
Depending on the particular situation, the LED Driver can be installed in the luminaire casing (in-built) or outside the casing (remote).
Dimensional drawings and installation instructions will help you take account of the requirements of the particular situation.
2.3. Electrical aspects
Special Tridonic connecting cable is available to ensure efficient and reliable connection between the modules and the LED Driver.
All the connection options, the connections between the LED Driver and the power supply and the connections of the control lines are
shown in relevant wiring diagrams.
2.4. Optical aspects
The overall efficiency of the system is improved by choosing a reflector with suitable optical properties (e.g. beam angle) and
dimensions.
This chapter provides information to support customer-specific reflector design.
2.5. Thermal aspects
The system modules have been designed to operate with a passive or active heat sink and can be mounted directly on such a suitable
heat sink.
In the case of active cooling the fan can be connected directly to the module or LED Driver depending on the version.
2.6. Ordering information and sources
The ordering information for the components and the sources for heat sinks, reflectors and accessories can be found at the end of the
document.
...
