Technical Design-in Guide Engine LLE G2 PRE KIT | 03-2020 | 1.2 | en
Electrical Aspects
c
28 / 63
5.3. Electrical connections
5.3.1. LLE G2 PRE module connections
The LED Driver is connected to the power supply and the connections of the control lines and the LED module via push-in and spring
terminals:
Line cross-section and stripped length of the insulation on the LED module
Line cross-section and stripped length on the LED Driver
Release of the wiring
Permissible line cross-section: 0.2 - 0.75 mm²
_
Stripped length of the insulation 6 - 9 mm
_
Push-in terminal for solid conductors
_
Permissible line cross-section: 0.5 - 1.5 mm²
_
Stripped length of the insulation 8 - 9 mm
_
Push-in terminal for solid conductor
_
Loosen wire through twisting and pulling or using a Ø 1 mm release tool.
_