Manual LCO EXC3/ADV3 OTD | 03-2020 | 1.2 | en
Installation notes
c
22 / 63
Safety information
...
I
NOTICE
The cabling, wiring and mounting for a LED Driver varies depending on the design and manufacturer of the LED module.
The following description should therefore not be viewed as comprehensive installation instructions but merely as important
general information.
To obtain further information, proceed as follows:
Read the documentation provided by the lamp manufacturer. Follow the guidelines and instructions of the lamp
manufacturer!
_
Observe all relevant standards. Follow the instructions given in the standards!
_
½
WARNING!
Comply with the general safety instructions (see
) !
_
To avoid failures due to ground faults protect the wiring against mechanical loads from sharp-edged metal parts (e.g. cable
penetrations, cable holders, metal frames, etc.
_
LED Drivers from Tridonic are protected for a maximum of 48 hour against overvoltage of up to 320 V. Make sure that the
LED Driver is not exposed to overvoltages for long periods!
_
LED Drivers of the LCO OTD series from Tridonic have type of protection IP 20. Comply with the requirements for this type
of protection!
_
