STEP 5
:
Installing the front wheels.
Remove the wheel cap and bolt using a 4 mm Allen
Wrench. Sometimes there are very thin washers that we use to micro adjust the
wheel/brake rotor position that also need to be temporarily removed. We normally put a
little lithium grease on the spindle that will make removing wheels easier later, but this is
optional. Look at the tire or the brake rotor on the wheel to determine which is the left or
right wheel. Rotate the brake caliper out of the way and put the wheel on the spindle. The
spindle has a small end that goes through the outer bearing. Put the wheel cap, thin washer
(if any) into the end of the spindle and retighten fully using a 4mm allen wrench. Make
certain that the brake caliper is completely rotated out of the way of the brake rotor.
