
Connecting your attachment
Prior to use you must ensure you lock the attachment in place using our
specially designed locking method to ensure it does not move whilst in use.
Simply
–
LIFT
–
SET
–
DROP
1)
Lift one side of the Triclimb off the floor by a few inches.
2)
Carefully bring the attachment to the desired rung and hook the
shallow cutouts over the rung as shown in figure 2
3)
Gently drop the Triclimb to the floor and the accessory will become
locked in position.
REMOVING
the accessory is the reverse of connecting.
WARNINGS
*It is extremely important that you read and retain the information in this
WARNINGS
section to reduce the risk of injury.
*Always ensure the attachment is correctly secured in place prior to use
*Children must be supervised at all times while using the Tri Climb attachment.
*No running, pushing or fighting.
*Only use the attachment for its intended purpose.
For indoor use only,
in a
domestic setting.
*Tip over hazard - Place play-frame on a level surface.
*Keep floors free of trip hazards and observe an obstacle free safety zone of at
least 2m in all directions around the unit.
*To minimise risk of injury from falling, do not install over a hard surface; a
protective surface should be used. Maximum vertical fall height - 590mm
*Never allow children to play with ropes, clotheslines, pet leashes, cables, chains
or cord-like items when using this play-frame attachment or to attach these items
to the play-frame.
*Never allow children to wear loose fitting clothing, ponchos, hoods, scarves,
capes, necklaces, items with draw-strings, cords or ties when using this Tri Climb
attachment.
*Do not allow children to wear open toe or heel footwear like sandals or flip
–
flops whilst climbing.
*Do not permit rough play or use of equipment in a manner for which it was not
intended.
*Observe capacity limitations of your play-frame - 1 user maximum.
*Recommended age: 0+ months
*Weight limit
–
100kg
*Risk of entrapment connecting - Never allow children to connect or disconnect
the attachment.
WARNING
–
When using the accessory as a
SLIDE
it must not be placed
on the very top rung of the Triclimb. It must be connected between two
rungs with one rung above and one rung below in order to lock.
2
3
1