Trickstuff GmbH
Schwabenmatten 17 A | D-79292 Pfaffenweiler | Germany
+49 (761) 88 78 91 0 | [email protected] | www.trickstuff.de
April 2022
Manual
CNC-Brake adapter
PM-PM+43
Dear Customer,
thank you for purchasing a CNC machined Trickstuff brake adapter. These adapters are made of 7075-T6 aluminum and
are extremely light with 14 grams (total weight without bolts).
Delivery contents:
�
1 Adapter PM to PM, +43 mm
Please be sure to follow these instructions:
�
7075 T6 aluminum is susceptible to corrosion, especially when exposed to salt, despite the high-quality anodized
surface. To protect the adapters from this, they should be sprayed with spray wax and polished before installation,
not only when used in winter.
�
Position the labeled side, facing away from the wheel.
�
First attach the adapter to the fork or rear triangle using M6 bolts (Length 16 mm, strength class at least 8.8 or A4-70)
with washers (maximum 11mm diameter). Maximum tightening torque given by frame or fork manufacturer but not to
exceed 8Nm.
�
Now mount the brake caliper with M6 screws (length 16 mm, strength class at least 8.8 or A4-70) with washers
(10mm maximum diameter, sharp edge of the washers pointing upwards!) on the adapter and adjust the brake caliper
centered over the brake disc.
�
Use only screws with medium strength thread locker or apply 1 drop each of Loctite Medium Strength to the bolt
threads.
�
Tightening torque of the screws is 6 to 8 Nm.
Use M6 Screws (Length 16 mm, strength class at least 8.8 or A4-70).
�
Check the tightening torque before each ride.
Enjoy your Trickstuff CNC brake adapters!
• Warning: improper use or assembly can result in serious injury or death!
• The following regulations are imperative for the proper function of the braking system.
• The assembly and removal of brake adapters should only be carried out by a qualified bicycle mechanic. In case of
doubt, contact a qualified dealer.
• Inspect the brake adapters before every ride. In case of corrosion or damage, stop use immediately and replace with
a new adapter.
• The brake adapters should only be used with compatible brake calipers, frames, forks, and brake discs.
• Do not attempt repair of brake adapters. In case of damage, stop use immediately and replace with a new adapter.
• Do not modify brake adapters.
Page 2 of 2