Tricity Bendix Visor CH 520, Инструкции по эксплуатации и монтажу

Страница: 4 / 12

This instruction book applies to the
following models:
Tricity Bendix CH520B Brown 50cm
Tricity Bendix CH520W White 50cm
Tricity Bendix CH610B Brown 60cm
Tricity Bendix CH610W White 60cm
This cooker hood is guaranteed and will
give lasting service. The guarantee is only
applicable if the hood has been installed in
accordance with the installation instructions
detailed in this booklet.
This cooker hood has been designed for
use fixed beneath a wall cabinet or directly
onto the wall using the special brackets
supplied and should be installed in
accordance with the following fitting
instructions.
The cooker hood can be used to extract
odours to the outside or to recirculate the
air within the kitchen after passing the
contaminated air through a cleansing
charcoal filter which is supplied as
standard.
The cooker hood is convertible to either
function by the movement of a change-over
slider control. This enables the cooker hood
when installed in the extraction mode, to be
converted to recircu-lation during the winter
months.
The installation instructions which follow
give instructions on how and where this
hood may be fitted. If already installed
check with the installer that all the
requirements have been met. If not then
draw these to the attention of the installer
who should be a qualified electrician or a
competent person.
Tricity Bendix disclaims all liability for any
damage or injury caused as a result of not
following the instructions contained in the
following text.
Width: CH520B - CH520W 498mm
Width: CH610B - CH610W 598mm
GENERAL INFORMATION ELECTRICAL CONNECTION
3
Before connecting to the mains supply ensure that
the mains voltage corresponds to the voltage on
the rating plate inside the cooker hood.
WARNING: THIS APPLIANCE MUST BE
EARTHED
This appliance is fitted with a 3 core mains supply
cable and should be permanently connected to
the electricity supply via a double-pole switch
having 3mm minimum contact gap on each pole.
A Switched Fuse Connection Unit to BS.1363 Part
4 (fitted with a 3A fuse), is a recommended mains
supply connection accessory to ensure compli-
ance with the Safety Requirements applicable to
fixed wiring instructions.
CONNECTION TO THE MAINS POWER
SUPPLY
Any permanent electrical installation must comply
with the latest I.E.E. Regulations and local
Electricity Board regulations. For your own safety
this should be undertaken by a qualified
electrician e.g. your local Electricity Board, or a
contractor who is on the roll of the National
Inspection Council for Electrical Installation
Contracting (NICEIC).
WARNING: INCORRECT INSTALLATION
COULD AFFECT THE SAFETY OF THIS
CHIMNEY HOOD.
DISCONNECT THE HOOD FROM THE MAINS
SUPPLY BEFORE CARRYING OUT ANY KIND
OF MAINTENANCE OR CLEANING.
This appliance conforms to BS.800:1988 and
EEC Directive 87/308 regarding suppression of
radio and television interference.