OPERATION
Make sure the jug and the lid are secure and locked. Set the selector to
‘0’.
Plug the
blender into the mains and switch on the power.
Operating Modes
Continuous (Normal) Mode
Select the desired operating speed.
There are three speeds. Move the
Selector knob to the right to increase
the speed. When you start blending
use the low speed to begin with
and select the high speeds only if
necessary. To stop the operation, turn
the knob back to
‘0’
.
Pulse Mode
Use this mode where ingredients need to be blended in small repeated bursts.
Set the Selector to
‘0’
.
Press the Selector knob and hold it there for a short period.
To stop the operation, release the knob.
Turbo Mode
Using the Pulse button to accelerate blending:
Select position
‘1’
or
‘2’.
Press the
Selector knob in briefly to accelerate the blending speed. The Pulse button has no
turbo effect in Position
‘3’.
Note:
Do not run the appliance continuously for more than 3 minutes. After a full 3
minute cycle allow the blender to rest for another 5 minutes before using it again.
During blending:
You can feed in small amounts of food or liquid through the jug lid. To do this turn
the stopper slightly to free it and lift it out. Gradually feed pieces of food or liquids
into the jug through the feeder. Replace the stopper when you have finished.
Use the stirrer to distribute the contents of the
jug. There is a slot in the stopper to allow you to
insert and remove the stirrer.
The stirrer may be safely left in the jug during
blending.
Never blend hot liquids in the blender. This is dangerous as the contents may
erupt. DANGER OF SCALDING!
If you spill liquid on the liquidiser base immediately switch off and wipe dry.
After you have finished blending:
Set the Selector knob to ‘0’.
1.
Remove the stirrer if you are using it.
2.
Rotate the lid of the jug anti-clockwise (towards you) to free it. Lift off the lid.
3.
Hold the jug carefully and turn it anti-clockwise (towards you) to release the
4.
jug from the motor base. (This may be easier with one hand on the base and
one hand holding the jug handle).
Remove the jug and pour or spoon the contents out carefully.
5.
Switch the blender off and unplug it after use.
6.
Operat
ion
6
Содержание TBL10
Страница 1: ...Instruction Manual TBL10 Electric Blender ...
