25
Adjusting the worktop
You can move the worktop forward or backward by
25 mm in order to align the machine with other kitchen
units.
Simply unscrew the two rear retaining screws, move
the top to the required position and then retighten the
screws.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it
under a close fitting sink unit or a pre-existing top,
providing the dimensions of the recess correspond to
those shown in the picture.
Proceed as follows:
-
Remove the machine’s worktop by unscrewing the
two rear retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling
with the adjustable feet. When inserting the machine,
ensure that the water inlet and drain hoses are not
kinked or squashed.
Levelling
Good levelling is essential for correct closure and
sealing of the door.
When the appliance is correctly levelled, the door will
not catch on the levelling spacers on either side of the
cabinet.
If the door does not close correctly, loosen or tighten
the adjustable feet until the machine is perfectly level.
INS18UKen
IN26
820
570 - 600
600
IN05
IN06
IN07
Содержание CDW 101
Страница 1: ...Dishwasher CDW 101 OPERATING INSTALLATION INSTRUCTIONS ...
Страница 26: ......
Страница 27: ......