Menu Operations
34
♦
Press [Volume Up/Down / Channel Up/Down] to position the
round mark.
♦
Press [OK] to set your stone.
♦
Press [MENU] to quit the game and return to the game menu.
6.4 Factory Default
When you press [OK] on the “Factory
Default” item:
1. A dialogue box will occur where you
need to enter the password.
2. After you input the correct password a
warning message will be displayed
like the one beside.
3. If you select “Yes” then all changes
you made will be reset to default
values. Make sure you really want to
do this!
4. Press [MENU] in both steps will close the window without resetting the
receiver.
6.5 Software Upgrade
1. This function allows you to upgrade
the software of the receiver. This can
be done from PC to receiver or from a
master receiver to a slave receiver.
2. Connect master receiver or PC to the
slave receiver via serial
interface(0-Modem cable). Enter the
“Software Upgrade” menu of the
master receiver and press [Volume
Up/Down] to change the upgrade
mode. Upgrade modes include: allcode / maincode / CAS-data /ScriptGUI /
Radioback / default db / userdb.
3. Switch on the slave receiver.
4. Mark “Start” on the master reeciver and press [OK] to start upgrade.
Wait until the display on the front panel shows “END”. Then switch off the
receiver and on again. Now the new software is used.
5. Press [MENU] to save the setting without upgrade.
