Triad CR
Surround
2 w/ OnWall Bracket - Quick Start Guide
2014.
11.4
CR
Surround
2 Installation with OnWall Mounting Bracket
CR
Surround
2 Speaker
- Installation Instructions -
Page 2
B
Ceiling
>/=24
inches
(61cm)
*
>/= 12inches
(30.5cm)
A
1.
Position & level speaker using Bracket Spine A.
Mark all 7 holes. Position speaker top at least12
inches (30.5cm) below ceiling & speaker bottom
at
least 24 inches (61cm) above ear level
(* except for
Atmos listener level surround speakers).
2.
For safety, mount speaker to stud or plywood
backed drywall if possible. ALWAYS fasten ALL 7
marked hole locations to minimize vibrations. If
mounting on a wall backed by a single stud, use wall
anchors B in the remaining 4 holes. Drill pilot holes
for all anchors with 3/8”(9.5mm) drill bit.
3.
Using ALL 7 #10 Oval Philips
screws (C), securely screw
Wall Bracket A onto wall.
4.
Place 2 sets of 1/4-20 Allen screws, lock washers, & flat wash-
ers D on speaker top. With ladder man holding speaker, the
underneath man supports it from below & guides bottom
bracket onto Bracket Spine’s A lower hooks. The speaker is
now supported from below by its bracket on the spine.
5.
Push speaker top toward wall, sliding top bracket
between the spine’s top 2 arms. Insert Allen screw
D with lock washer & flat washer through the slot in
the spine’s top arm; loosely hand tighten into
nut captured in the top bracket. Repeat on oppo
site side. Adjust downward tilt as needed. Swivel
speaker to expose bolts and tighten both sides with
supplied Allen wrench.
6.
Swivel speaker to expose bolts and tighten 2
bottom bracket screws with Allen wrench.
7.
Swivel & aim speaker horizon-
tally to a max of +/- 12 degrees
When angle is correct, tighten
bottom & top bracket hex bolts
with 9/16” (14mm) socket to fix
swivel angle.
8.
With spades or bare wire (do not
use Bananas – they interfere
with the endcap), connect speak-
er wires to binding posts observ-
ing correct polarity.
9.
Set bottom & top end caps in
place (neo magnets keep them
fixed). Press fit two grills if desired.
Speaker install is complete
.
Top
Bracket
