Please note that remote trainers are not designed to be worn
continuously by a dog. To prevent irritation caused by rubbing,
remove the collar for at least eight hours out of every 24-hour
period. See the additional information in the Product Safety section
of this guide.
Setting the Intensity
Your Sport
®
G2 Remote Trainer can give corrections at different lev-
els so you can find the best level for your dog’s temperament and your
type of training.
There are two ways to change intensity level: by moving the intensity
dial or by selecting a different stimulation button.
The DVD that comes with your remote trainer has some intensity
selection tips.
Intensity Dial Functions
“N” Transmitter is disabled. No tone, beeper, or stimulation
functions are possible. This setting is intended for times
when your transmitter buttons might be accidentally
bumped or pressed.
“T” The stimulation buttons produce tone instead of stimulation.
The meaning of the tone is determined by your dog’s training.
Some intensity dials have the “N” feature and some have the “T”
feature. No dial has both “N” and “T.” Consult the Model Guide
for the features of your model. On all models, stimulation is only
produced if the dial is set on a number rather than on “N” or “T.”
Fitting the Collar on the Dog
Place the collar strap in the middle
of the dog’s neck. The receiver
should be on the underside of his
neck although on some dogs’ necks
the receiver will naturally seek a
slightly off-center position. The
receiver light should face forward
(towards the dog’s nose). The
charging contacts should face
backwards (towards the dog’s chest).
Tighten the buckle by holding it with two
fingers as you pull the strap snug. Remote
training collars must be on a dog quite
snugly to ensure consistent contact and
reliable stimulation. Do not put any fingers
under the strap as you tighten it. Slip the
free end of the strap through the keeper
that is present, and through both sides of a
double-sided buckle.
You can easily adjust the strap for different sized necks by moving the
receiver to a new position on the strap. If the strap is too long for
your dog, cut off the excess length. Leave enough length to go
through the keeper with at least 3 inches to spare.
NOTE: Do not cut the collar strap of the Sport
®
65 BPR G2 until
you have also installed the Beeper on the strap or your cut strap may
be too short to reach around both the receiver and the Beeper.