TRI tool BEVELMASTER 212B, Инструкция по эксплуатации

Страница: 15 / 28

15
Model 212B Miter Mandrel Head for SP/FF
92-0738 : Rev. 980331
If not, locate the four (4) Parallel Offset Adjusting Screws and back off one (1)
or two (2) screws where the Adapter Plate Assembly is ‘in’.
Tightening to opposite one or two screws will bring the Adapter Plate Assembly
toward the center.
NOTE: To make the Parallel Offset adjustment. All four (4) screws must be
slightly loose.
Once the Adapter Plate Assembly has been roughly aligned and centered,
temporarily snug all of the Adjustment Screws and the Draw Nut.
Insert the Miter Mandrel Head into the work-piece.
NOTE: It is highly desirable to mount the Miter Mandrel head so that Angular
Offset Pivot Point is on the same plane with the proposed finished weld
preparation.
Installation of the Indicator Sleeve Assembly