TRI tool 302, Руководство по эксплуатации

Страница: 21 / 38

Model 302 Tube Squaring Machine
92-0547 Rev. 210906 21
Feed Knob
Tube or Pipe
Cover
Figure 7: Rotate the Feed Knob
§
If the tube or pipe end is not square to the tube or pipe axis, the tool bit will contact
only a small segment of the tube or pipe during each revolution.
§
To avoid tool bit damage, use a very slow feed rate until the tool bit contacts the
tube or pipe continually during at least one revolution.
5. Continue rotating the feed knob clockwise until the end of the tube or pipe is
completely machined. Do not let the tool bit(s) cut into the saddle.
6. Discontinue the feed and allow the cutting head to rotate one to three more revolutions
to improve the finish of the prep surface.
7. Rotate the feed knob counterclockwise to separate the cutting head and the tube or
pipe.
8. Stop the tool rotation.
9. Release the trigger on the motor.
10. Rotate the feed knob counterclockwise until the cutting head clears the tube or pipe by
at least 1/8" (3 mm) or more.
11. Loosen the upper saddle to release the tube or pipe.