Page 12
STEP 4: APPLY OIL AND POWDER
This process is similar to charging the disc.
1.
Spin disc by hand.
2.
Hold atomizer 8‐10 inches above disc.
3.
Apply a 1 – 2 second burst of oil from atomizer as disc rotates
4.
Apply honing powder evenly around disc with the supplied shaker.
5.
Place wooden charging stick on disc and make 2‐3 revolutions around disc
spreading powder and filling the fine grooves on the disc.
6.
This is to be done with each blade sharpened.
STEP 5: SHARPEN BLADES
1.
Turn on disc and automatic arms.
2.
Lower comb onto disc setting down between inner and outer edges of disc.
3.
Lower cutter onto disc setting down between inner and outer edges of disc.
4.
Cycle for 2 minutes on low speed (reduce cycle to 1 minute if disc is set to
high speed).
5.
Lift arms off disc when holders are between inner and outer edges of disc.
6.
Inspect powder residue on blades, powder should be moist enough to
adhere to blades, if powder is dry like sand or flour then you are not using
enough oil, if powder is wet like grease or toothpaste then you are using
too much oil. If powder is too wet simply apply powder only (no oil) until
powder residue is correct.
7.
Wash blades in blade wash, mineral spirits or kerosene to remove all
powder from blades. We recommend 2 containers the first container is
what the blade is washed in and the second container is for rinsing the
blade. Recommend using small paint brush to clean between the teeth of
blade.
8.
Place comb back on metal removal gauge and measure amount of metal
removed in sharpening process. Needle should be 2 lines from zero
indicating you removed .002” from blade.
Содержание 3000
Страница 1: ...Treyco Model 3000 Instruction Manual ...
