TREVIDEA Girmi RC30, Руководство пользователя

Страница: 14 / 32

13
TIPS FOR CUTTING
- Make sure that the device is fully charged before starting the cutting process.
- Use only on clean and dry hair and never use it on wet hair.
- Make sure that the head of the person whose hair you want to cut is at the same level as your shoulders; in
this way, each cutting zone will be clearly visible.
- Cut hair in the direction of growth (see Fig. 5).
- Install the cutting attachment as described in the previous paragraph.
OPERATING THE UNIT
1. HAIR CLIPPER
- After having installed the attachment (B) to the unit, connect one of the 4 hair clipper combs (A) to the
attachment (B) and on both sides until it clicks in position.
- Without the comb the cutting height can be set to 3 levels (0.8 - 1.1 - 1.4mm) using the selector on the
upper part of the appliance.
- Choose the comb depending on the desired level, as indicated in the below table:
Comb Hair length (after clipping)
Without comb 0.8 - 1.1 - 1.4 mm
1 3 mm
2 6 mm
3 9 mm
4 12 mm
Note: when you are trimming for the first time, you may want to start with the longer length to familiarize
yourself with the appliance.
-
Turn on the unit by moving the operation switch (M).
- Move the device slowly in the direction of hair growth: since the hair does not grow in the same direction, it
is recommended to move the clipper in various directions.
- For best results, make sure that the flat part of the comb is always in contact with the scalp.
- Make several passes over the head to ensure you cut all the hair you need to.
- Regularly remove remaining hair on the comb. If you need, switch off the appliance to remove the comb
(A) and clean the cutting blade.
CONTOURING WITHOUT THE COMB
The device can also be used without the cutting comb (A), to cut very short hair (0.8-1.4
mm long), to contour the neckline, the sideburns and the area near the ears.
WARNING: Be careful when using device without the comb since the blades are very
sharp.
- Extract the cutting comb (A).
- Before finishing the outline on the neck or around the sideburns, fade hair above the ear.
- Tilt device so that only one edge of the blade touches the hair to finish the nuances
around the ear.
- To contour sideburns or neckline, turn the appliance and make downward strokes,
always following the natural hairline.
2. PRECISION TRIMMER
- Connect the precision trimmer (O) to the unit as described in "How to connect cutting
attachments" paragraph.
- Use this accessory to shape your mustache, sideburns, to contour beard or to remove
single hair.
- You can use the trimmer (O) to design hairstyle with drawings and lettering (see Figure 12). Hold the
device upright and trim the desired area.