TDS-225/750 T
6287
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel,fax:+48 58 56 300 80 www.ega.com.pl
7
For example, if an abrasive wheel is snagged or pinched by the workpiece,
the edge of the wheel that is entering into the pinch point can dig into the
surface of the material, causing jumps or expulsion of the grinding wheel.
The wheel can jump towards the operator or by moving away, as the
direction of movement of the grinding wheel at the point of pinch.
Abrasive wheels may also break under these conditions. Kickback is the
result of misuse of the tool and / or procedures or conditions incorrect
operation and can be avoided by taking proper precautions specified
below.
a) Maintain firmly the power tool and position your body and arm for
you allow to resist kickback forces. Always use auxiliary handle, where
applicable, for maximum control of kickback or torque reaction during
startup. The operator can control the reaction torques or forces rebound,
if precautions are taken.
b) Never place your hand near the rotating accessory. The accessory can
perform a bounce on your hand.
c) Do not place you in the area where power tool will move if kickback.
The rebound pushes the tool in the opposite direction to movement of the
wheel in point hooking.
d) Take special care when working corners, sharp edges etc.
Avoid twists and snaps of the accessory. Corners, edges or sharp twists
tend to hang the rotating accessory and cause loss of control or kickback.
e) Do not attach a saw chain, blade wood carving saw chain or toothed
saw blade. Such blades cause frequent rebounds and control losses.
4. A
DDITIONAL SAFETY INSTRUCTIONS FOR SANDING OPERATIONS
Set specific security guard for sanding
a) Do not use sandpaper too oversized for sanding discs.
Follow manufacturers' recommendations when selecting sanding paper.
More abrasive paper extending beyond the sanding pad presents a
laceration hazard and may cause a crash, tearing of the disc or kickback.
