10
NOTICE
This unit can evaporate the condensation and distribute through the exhaust hose
automatically.
1.
When the unit is in the cooling function, it does not need the drain pipe installed.
Please make sure that the rubber cap“
①
” is locked on drain hole, when the unit is
running.
2.
When operating the heating function, the “
①
” rubber cap on drain hole should be
pulled out and install a proper drain pipe in order to improve the heating effect.
3.
When operating the dehumidifying function, the “
①
” rubber cap on drain hose
should be pulled out and install a proper drain pipe
②
.
●
Please remove the air exhaust hose, connect a drain hose to the drain hole and lead
the water to the outside in order to intensify dehumidifying capacity.
※
Please install a proper drain hose
②
to drain off water.
※
The water will drop into the water tank if without drain hose. When the water tank is
full, "E4" will be displayed on the display panel. Please remove the rubber
cap“
①
”of the drain hole to drain out the water first. After the drainage is completed,
please restart the unit and then the unit can operate normally.
MAINTENANCE
PLEASE DISCONNECT THE POWER CORD BEFORE
CLEANING.
AIR FILTER
The air filter located on the left hand side of the unit can be removed,
simply by pulling the frame out
11
CONDENSER/EVAPORATOR
Use a brush attachment with a vacuum cleaner.
Casing
Wipe with a damp cloth and polish with a soft cloth.
To remove the air filter, please follows the arrow direction and pull the
filter lightly, and then take out the filter for cleaning.
POWER SUPPLY
(1)
Confirm the correct power.
(2)
Insert the plug into the outlet firmly In order to prevent any
dangerous leakage.
(3)
Don’t pull power wire by force because it will cause damage to power
wire.