34
HEX input format:
Hex format causes each pair of characters you type to be
interpreted as an eight-bit value in hexadecimal (base 16) notation.
Only the digits 0 through 9 and the letters A through F (in upper
or lower case) are valid. To setup 64-bit WEP key, input 10 HEX
format, for example, ‘3132333435’, this is the same with ASCII
input ‘12345’. To setup 128-bit WEP key, input 26 HEX format,
for example, ‘31323334353637383930313233’, this is the same
with ASCII input ‘1234567890123’. These character counts
result in bit counts of 40 and 104, respectively; the Wireless
Internet Camera will automatically pad your input to a bit count
of 64 or 128.
On the Confirm WEP Key field, input the same characters as the
Encryption Code field.
Make sure the Encryption Code is the same with the access
point’s encryption code that the Wireless Internet Camera is to be
connected under Infrastructure mode. Your PC/Notebook’s
encryption code also needs to be setup the same with the Wireless
Internet Camera's encryption code under either Infrastructure
mode or Ad-hoc mode.
The default setting for the Encryption Key is Disable therefore, to
secure the wireless transmission be sure to Enable the Encryption
Key by entering the relevant data.
Note:
Carefully input Encryption Code, any error setting will cause
communication link to fail.
35
LED Control:
The LED control allows user to setup the LED illumination as
desired. This feature provides the flexibility when surveillance
activity is ON.
There are three options as follows:
z
Normal –
Power
- Steady On of the LED indicator.
Link
- Steady On of the LED indicator. When
WLAN activity is present the LED indicator will
flash steadily.
z
OFF –
Power
- LED indicator is off
Link
– LED indicator is off
z
Dummy –
Power
- Steady On of the LED indicator.
Link
-
Steady On of the LED indicator with
random flashing.
The default setting for the LED control is at Normal. When you
have configured the LED control, the correct illumination will be
set after 1 minute.
Note:
This function is built-in to the LED indicators to add extra
capabilities. The three options allow the Administrator to
configure and camouflage the illumination for the LED indicator
to falsify the monitoring status. In Normal Mode, the LED
indicator functions normally. Under Off Mode, the LED
indicators are both off; however, it is still monitoring the activity.
In Dummy Mode, the LED indicators operate in monitoring
condition but monitoring activity is off or on.