TRENDnet TPL-401E, Быстрое руководство по установке

Страница: 8 / 12

1.
1.
I have verified that my Powerline device is connected to my workstation, but I cannot
detect other Powerline devices. What should I do?
1. Verify that you are using Cat. 5, Cat. 5e or Cat. 6 Ethernet network cables for each
TPL-401E adapter.
2. Verify that the power outlet of the TPL-401E adapter is plugged into is on the same
electrical system and/or circuit breaker box.
3. If you are still not able to establish connectivity after performing the above steps, please
reset both of the TPL-401E adapters to factory default. The default network name/key is
“HomePlugAV”. The Reset button is located on the bottom of the TPL-401E.
1. With a pin or paperclip, press and hold the reset button for 1 second and release it.
The LEDs will turn off and turn back on.
2. To verify connectivity, the PL LED will become solid when the powerline adapters
establish connectivity. The TPL-401E powerline adapters must have the same
network name/key in order to connect to each other.
Note: If you have problems resetting the device, unplug the powerline adapter(s) from
the power outlet, wait 15 seconds and plug the adapter(s) back into the outlet, then
repeat the reset procedure.
2. I can detect my Powerline devices on my Powerline network, but I cannot connect to the
Internet. What should I do?
Assuming that the Powerline network is connected to a router:
Make sure you are not connecting the device into a surge protector or power strip.
2. Make sure that your Router is connected to the Internet and one of the Router's LAN ports
is connected to the TPL-401E's network port). Check both TPL-401E and the router's
network port LED for positive connection status.
3. Make sure your computer's TCP/IP settings are set to Obtain an IP address
automatically (see the steps below).
Troubleshooting
6
Windows 7
1. Go into the Control Panel , click Network and
Internet , click Network and Sharing Center , click
Change Adapter Settings and then right-click the
Local Area Connection icon and then click
Properties .
2. Click Internet Protocol Version 4(TCP/IPv4)
and then click Properties. Then click on
Obtain an IP address automatically.