5
Note:
1. DIP switch settings can be changed at any time. Users can either (1)
unplug the power supply, change the DIP switch settings, and plug
in the power supply; or (2) change the DIP switch settings and
power cycle the device.
2. The default setting on Dip Switch 2 is set to “Off” (Auto-Negotiation)
position. Put in “On” position only when the other end of the fiber
converter is required to use Force mode.
3. LLCF stands for Link Loss Carry Forward. To use this function, both
sides of the fiber converter must support LLCF function. Only enable
LLCF function in one of the fiber converters. When one side of the
Ethernet TX cable loses signal, the LED on that unit will turn off (the
other unit's Ethernet TX LED will remain lit). When one unit's Fiber
TX or RX is lost, the FX LED on both units will shut off. The
connected device may changed LED behavior.
2
1
Off
Off
Action
On
Function
LLCF Disable
On
Switch
LLCF Enable
Fiber Forced Mode
Fiber Auto-Negotiation
Dip Switches
