TRENDnet TEW-734APO, Руководство пользователя

Страница: 15 / 65

© Copyright 2015 TRENDnet. All Rights Reserved.
14
TRENDnet User’s Guide
TEW-734APO
Wireless Client Mode
This section outlines available management options when the device System Setting is
set to
Bridge and the wireless Operation Mode is set to Wireless Client . Click Apply to
save any changes.

Disable Wireless LAN Interface:
o
Check/Off: turns off wireless networking on your router.
o
Unchecked/On: turns on the wireless networking on your router (by default
it is enabled).
Note: It is recommended to leave the wireless setting to On unless you do not plan
on connecting any wireless computers or devices to your network.

Operation Mode: Select the mode you want the access point to operate in.
o
AP : refer to page11 for additional information.
o
Wireless Client : refer to page13 for additional information
o
Bridge : refer to page 16 for additional information
o
AP Repeater : refer to page18 for additional information to operate the
device as an access point.

Site Survey: Click to scan and select available wireless networks.

Wireless Network Name (SSID): This acronym stands for Service Set Identifier
and is the name of your wireless network. You can manually enter the wireless
network you want to connect to or click “Site Survey” option to scan for available
wireless networks around you. Ple

Lock AP MAC: Enter the MAC address of the access point you are connected.

802.11 Mode: If all of the wireless devices you want to connect with this Access
Point can connect in the same transmission mode, you can improve performance
slightly by choosing the appropriate mode. If you have some devices that use a
different transmission mode, choose the appropriate mode.
o
802.11A/N mixed mode - This wireless mode works in the 5GHz frequency
range and will allow both wireless A and wireless N (5GHz) client to connect
and access point.
o
802.11 A (5GHz) - This wireless mode works in the 5GHz frequency range and
will only allow the use of only wireless A client devices to connect.

Data Rate: Usually “ Auto ” is preferred. Under this rate, the IEEE 802.11b/g/n
Wireless CPE will automatically select the highest available rate to transmit. In
some cases, however, like where there is no great demand for speed, you can
have a relatively-low transmit rate for compromise of a long distance.

Output power: Specify the signal transmission power. The higher the output
power is, the wider the signal can cover, but the power consumption will be
greater accordingly.

Enable MAC Clone: Available only under wireless client mode, it hides the MAC
address of the AP while displays the one of associated wireless client or the MAC
address designated manually.
Site Survey
The following section outlines how to utilize the site survey option in Wireless Client
mode.