Single port Multiprotocol Fast Ethernet Print Server Hardware User
Guide
6
Unpacking and Installation
1.
Confirm proper operation of the printer to be connected to the Print
Server.
2.
When you have confirmed proper operation of the printer, switch its
power off.
3.
Confirm that your network is operating normally.
4.
Connect the Print Server to the network through
the RJ-45 jack on
the print server
front panel.
WARNING:
Configuration problems may result if the
Server
is powered up without first establishing its
network connection. Follow this procedure to avoid
complications at the configuration stage.
5.
While the printer is off, connect the Print Server directly to the
printer
parallel port.
6.
Switch printer power on.
7.
Plug the AC power adapter
output plug into the Print Server
DC power input jack.
8.
Plug the AC power adapter into an AC power outlet. This will supply
power to the Print Server. (The Print Server has no power switch.)
The Print Server
self-test routines will proceed automatically.
Power-up and Self-test
Whenever the Print Server is powered up, two testing procedures
follow automatically. The first procedure is a programmed series of
flashes intended to confirm proper operation of the three LED
indicators. The second procedure comprises programmed tests of the
Print Server internal circuitry. If any fault is found during the circuitry
tests, testing stops and a continuous pattern of flashes signals the
nature of the fault.