TRENDnet TE100-P2U1P, Руководство пользователя, Страница: 66 / 74

Print Port Related Problems
Printing data failure may be caused by a loose connection of the print server to the
Centronics parallel port of the printer. Check to see if any of the pins on the 36-pin connector
are damaged. In addition, check the cable connection. If the pins are damaged, contact your
dealer for a replacement connector.
Windows 95/98/Me/NT/2000/XP Troubleshooting
Multi-Segment LAN Environment Installation (through the Network Print Port)
If your print server and Windows 95/98/Me/NT/2000/XP are located on two different
segments, and your Windows NT server is used as the router/gateway you will need to
implement the following procedures in order for your print server to function properly:
Add the RIP for NWLink IPX/SPX compatible transport. See RIP for NWLink IPX/SPX
compatible transport Installation Procedure later in this section.
Add the frame type 802.2 for both Ethernet adapters. See Multi-Segment Frame Type
802.2 Installation later in this section.
RIP for NWLink IPX/SPX compatible transport Installation Procedure
1. From your Windows NT server that is used as a router, select Start from the bottom left
hand corner of the screen.
2. Select Settings .
3. Select Control Panel .
4. Double-click the Network icon.
5. Select Services .
6. Select Add .
7. In the Select Network Service box, select the RIP for NWLink IPX/SPX compatible
transport . Click OK .
8. Follows the directions on the screen.
9. Done!
Multi-Segment Frame Type 802.2 Installation
1. From your Windows NT server that is used as a router, select Start from the bottom left
hand corner of the screen.
2. Point to Settings , and select Control Panel .
3. Double-click the Network icon.
4. Select Protocols . Select the NWLink IPX/SPX Compatible Transport .
5. Select Properties .
6. Select your (first) network interface card and select Manual Frame Type Detection .
7. Click Add .
64