TRENDnet TE100-H16R, Руководство пользователя, Страница: 26 / 34

Fast Ethernet Stackable Hubs User’s Guide
Making Connections 20
A crossover cable is a straight-through twisted-pair cable in which
the wires have been crossed. The figure below shows the pin as-
signments for a Fast Ethernet crossover cable:
There is 100BASE-FX optional module that may be added to any
of the hubs in the series. Each of the modules offers a 100BASE-
FX additional network interface that allows for greater flexibility
in how these hubs may be used in a network.
100Base-FX Module Installation
The installation procedure for each module is the same. Addi-
tional information about each module is provided below.
To install any of the modules: (Includes SC or ST type connectors)
1. Locate the module slot in the hub’s rear panel.
2. Using a screwdriver, undo the two screws and remove the dust
cover on the module slot.
3. Holding the module component-side up and connector-side in,
gently slide the module along the guides and seat it in the in-
ternal connector.
4. Using a screwdriver, replace the two screws and tighten until
snug.