Ethernet Card
for PCI
5
Section 2 Installation
This section describes how to install your Ethernet
hub card. Perform the following steps to install the
adapter.
1. Turn off your computer and all peripherals.
2. Make a note of the cables and cords that are
connected to the computer and disconnect them.
3. Remove your personal computer's cover (refer to
the owner's manual of your personal computer).
4. Select any available PCI slot, and remove the
slot cover.
5. Carefully install the Ethernet hub card into the
ex-pansion slot by firmly pressing the card into
the edge of the connector slot until the card is
snugly seated in the expansion slot and fasten
the retaining bracket with screw from the slot
cover.
6. Reinstall your personal computer's cover and
re-connect the power cord and all cables.
7. Connect the Ethernet cable to your personal
computer.
Note:
System Requirements:
A PC and BIOS that support the PCI Local Bus