Combi 1001
-9-
Length Stop Arrangement
OPERATION
Setting the Length Stop for the
Female Cut
Carry out the setting operation first:
■
Fit bushes into Green dot location holes
and offer the jig to the worktop as shown.
Face marked Green dot must be
uppermost.
■
Insert location bush in Red dot location
hole as shown, and position the jig across
the width of the worktop. Loosely fit the
length stop (or adjustable long clamp).
■
Fasten length stop (or adjustable long
clamp) to template so that it traps the
template across the worktop between the
Red dot location bush and the stop (or
adjustable long clamp). Tighten up the
knob.
■
Remove the bush from Red dot location
hole. The template is now set to cut the
correct length of joint.
■
Some carcasses may have their backs
reduced which means in turn the worktop
width will be reduced. Please take this into
consideration when setting the length stop.
Setting the Length Stop
Location bush
(Red dot)
Postform edge
Length stop on
underside. Retained
with screw & knob
Location bushes
(Green dot)
Worktop
Length stop
Washer
Jig
Knob
Using Adjustable Clamp Accessory
PJ/CL/L
Worktop
Bolt
Washer
Jig
Knob
PJ/CL/L Clamp
