– 1 –
EN
– 1 –
Mode: System
Switch to the "s
ysteM
" mode.
In this mode, you are provided with information on the memory and the installed firmware version. In addition,
you can change the user language, the load defaults, and delete the entire memory.
Memory / FW
Under the menu item "M
eMory
/ fW", you are given information on the entire memory and free memory,
and the installed firmware version.
Language
Under the menu item "l
AngUAge
", you can select the menu language of the player.
Default settings
Under the menu item "l
oAd
defAUlts
", you can restore the original settings of the
i.Beat xtension
.
The saved files are not deleted when you do this.
Delete all
Under the menu item "d
elete
All
", you can delete all of the files on the
i.Beat xtension
.
Notes:
This MP3 player is optimized for the provided headphones (32 Ohm impedance). Using other earphones with a lower impedance
can damage the MP3 player or earphone, especially MP3 players with 2 earphone jacks.
Exposing the unit to an electrostatic discharge, may interrupt the data transfer between the unit and the computer. If this occurs, the
unit should be unplugged from the USB port and then plugged in again.
Note: This device can produce high volumes. To prevent hearing loss, do not listen to high volumes for long periods. If you notice a
ringing noise in your ears, lower the volume immediately or stop using the MP3 player. Please keep in mind that using earphones or
headphones at loud volumes may result in permanent hearing loss. While you become accustomed to higher volumes over time,
so that they may seem normal to you, your sense of hearing can still be impaired. The higher you adjust the volume, the faster your
sense of hearing can be damaged.
Note: Using earphones while driving a motor vehicle is not recommended and is prohibited in some countries. Always drive carefully
and with full concentration. Stop using your MP3 player if you become distracted or interrupted by it when driving a motor vehicle
or during other activities that require your full attention.
Do not use USB cables longer than 3 meters.
The manufacturer retains the right to continually improve the product. These changes may be made without being directly
described in these operating instructions. For this reason, the information provided in these operating instructions may not
reflect the current state of the art.
The manufacturer only guarantees suitability for the product's intended purpose. In addition, the manufacturer is not responsible
for damages or loss of data and subsequent consequences.
Copyright © 007 TrekStor GmbH & Co. KG. All rights reserved. Other cited product or company names may be trademarks or
brand names of the respective owner.
•
•
•
•
•
•
•
•
•
