Trek Lync, Инструкция к добавке

Страница: 31 / 36

31
Trek
®
Lync
Supplement to owner’s manual
This manual provides instruction on use and
maintenance of the built-in lighting system
on the Trek Lync bicycle. It is a supplement
to the Trek Bicycle Owner’s Manual.
This manual is written for the owner and
does not require mechanical experience.
Some maintenance should only be
performed by the dealer, and this manual
tells you when that is.
® Trek is a registered trademark of the Trek Bicycle Corporation
© Copyright Trek Bicycles 2014
To See” light system
The lighting system on the Lync is a “To See”
system, intended to work as a head light in
low-visibility situations. The high-output LEDs
(Light Emitting Diodes) provide a bright, 550
lumen headlight in a focused pattern to
illuminate the road ahead. The rear lights
(two) are 3 lumens each.
This type of light meets lighting requirements
in most areas. Check with the local
authorities for the requirements in your area.
The other type of light system, “To Be Seen”
lights, provide a wide beam in a dispersed
pattern so that the light is visible from a
wider angle. For best results, use both types
of lights.
WARNING: A bicycle without
correct lights and reflectors might
be difficult for other people to see,
and you might not be able to see.
If you cannot see, or other people
cannot see you, you could have
an accident. Make sure your lights
operate correctly and that
batteries are charged.
Table of Contents
Foreword
“To See” light systemsi
Explanation of the system
Tools needed 1
Parts of the system
Battery pack 1
Dock 2
Lights 3
Control panel
3
Wires. 3
Riding with the Lync
Switching the lights off, on, and flashing 4
Battery indicator lights
4
Recharging the battery
4
Important:
The Lithium Ion battery should be fully
recharged before your first use, and
before any extended use.