Trek Domane SL 2020, Руководство по обслуживанию

Страница: 10 / 16

16 17
Di2 handlebar specifications for reference
DS shifter to
junction A NDS shifter to
junction A DS shifter to
junction B Battery to
junction B
FD to junction B RD to junction B
300 1200 1400
1
300 400 600
NOTE
1 This wire length will change with
respect to frame size, stem length, or bar width. All
other wire lengths stay the same regardless of frame
size.
7
SERVICE INFORMATION
8
APPENDIX
A. Install the front Isospeed
1.
Apply grease to the bore holes, as well as the
inside face and both sides of the head tube.
2.
Place a washer over each bearing in the front
IsoSpeed decoupler.
3.
Pinch the Front IsoSpeed decoupler between
two fingers to hold the washers, and carefully
guide it into the cavity in the head tube. Stop
when the holes in the decoupler are aligned
with the bore holes in the frame.
4.
From inside the decoupler, insert a screw into
the driveside bore hole so the screw points to
the outside of the head tube.
5.
Point the end of the elliptical nut with the
chamfer towards the bore hole.
CHAMFER
6.
Place a finger inside the decoupler and push
the screw towards the outside of the head
tube.
COLOR CODE, FOR DRAWING ONLY:
REAR BRAKE = RED
FRONT BRAKE = DARK GRAY
Di2 WIRE = LIGHT GRAY
RIGHT SHIFTER
- TO BAR END PLUG
- TO JUNCTION B
BAR END PLUG
- TO L SHIFTER
- TO R SHIFTER
THRU BAR,
OUT HOLE ON L DROP
UNDER BAR TAPE
JCT B
- TO R SHIFTER
- TO BATTERY
- TO FD
- TO RD