Trek 2022 E-CALIBER, Дополнение к руководству по обслуживанию

Страница: 18 / 22

2022 E-Caliber Service Manual
17
Carriage wiper seals and bushings (continued)
Replace the wiper seals
1. Wipe the seal surface inside the carriage to remove
debris.
2. Load a new seal onto each seal installation tool.
Seal
Use this side of the tool for pressing in
seals.
Bushing
Use this side of the tool for pressing in
bushings.
3. Put one tool with one seal into the front of the car-
riage, and the other tool with the other seal into the
rear of the carriage.
4. Insert the upper half of the headset press into the
front of the carriage.
5. Insert the lower half of the headset press into the
rear end of the carriage and lock it into place.
6. Spin the headset press until it is snug against the
seal tool. Check for correct alignment of the press,
tools, and seals. Rotate the press to push the seals
into place.
7. Tighten the press until you feel resistance. Once you
feel resistance, remove the press and tools.
8. Inspect the seals to verify there is no gap between
the seal and the carriage.
9. Soak the foam ring in 10wt fork bath oil.
10. Install the foam ring into the front of the carriage.