Trejon MULTIFOREST V Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 24 / 44

Instruction Manual MULTIFOREST Cranes (2005)
24
Mount the widening
wing inside the
machine
3.4 Operating the Machine
Warning!
Under no circumstances leave the driver’s position before the equipment has come to a
complete stop.
The machine must NOT be cleaned while in operation. Ensure no-one is present in the
vicinity of the machine.
When working with the crane in the vicinity of electric lines, electricity can jump over to the
equipment if any machine part should come too close or in direct contact with a conductor.
No persons or animals may approach closer than 25 m from the machine when in
operation. Maintain a good overview of the risk zone when working with the crane. The
machine and the tractor may overturn if the crane is not used correctly. It is strictly
forbidden to lift people with the crane.
Wet or icy logs must be handled with extreme caution. It is forbidden to stand under a
raised load.
Never drag a load that has become stuck and cannot be
freed with the crane’s own
hydraulic power by gripping the load and pulling with the vehicle, i.e. do not exceed the
crane’s maximum lifting capacity. This will cause the crane’s protective equipment to
malfunction, which may result in a fractured boom and uncontrolled movement.
NOTE!
The crane’s hydraulic package is equipped with pressure limiting and check valves to
protect equipment from overloading. These must not be interfered with.
The warranty does not apply to faults caused by incorrect operation.
A doubling of the work rate means the tool is exerted to 4x the stress. Do not operate the
machine faster than is necessary.
The crane must not be exerted to loads on longer boom lengths than the maximum crane
length corresponding to the weight of the load in question.
Ensure hydraulic hoses and pipes do not fasten on trailer or branches.
The crane may only be used in temperatures lower than -20

C in exceptional cases.
There should be an emergency stop placed close to the crane’s control levers (the
hydraulic power supply to the crane should be cut immediately the emergency stop is
triggered).